1.控制器通电后，使用微信扫描开关上的二维码，进入小程序管理页面。

2.点击添加设备，点击创建新项目，输入项目名称、选择位置后点击下一步，点击添加设备。

3.两种添加设备的方式：a.扫描开关上的条码，进行添加。b.打开手机蓝牙和GPS，搜索手机15米内的开关进行添加。点击开关名称，进入小程序控制页面。

4.可手动对开关进行控制。也可以设置定时开关。

5.两种定时模式：a.点击经纬模式，点击经纬度定时设置，选择开启和关闭的规则，点击确定。点击保存定时设置。

b.点击自定义模式，点击添加定时组，设置定时开、关的时间（星期、小时、分钟都是滑动选择，选择完成后记得点击确定），点击确定。点击保存定时设置。

1. After the controller is powered on, use wechat to scan the QR code on the switch and enter the applet management page.

2. Click add equipment, click create new project, enter the project name, select the location, click next, and click add equipment.

3. Two ways to add equipment: A. scan the barcode on the switch to add. b. Turn on the Bluetooth and GPS of the mobile phone and search the switch within 15 meters of the mobile phone to add. Click the switch name to enter the applet control page.

4. The switch can be controlled manually. The timing switch can also be set.

5. Two timing modes: A. click the latitude and longitude mode, click the latitude and longitude timing setting, select the opening and closing rules, and click OK. Click Save timing settings.

b. Click Custom mode, click Add timing group, set the timing on and off time (week, hour and minute are sliding selection, remember to click OK after selection), and click OK. Click Save timing settings.